Compare Every Size

• 5x525 sq ft
• 5x1050 sq ft
• 5x1575 sq ft
• 5x20100 sq ft
• 10x10100 sq ft
• 10x15150 sq ft
• 8x20160 sq ft
• 10x20200 sq ft
• 15x20300 sq ft
• 10x30300 sq ft
• 10x35350 sq ft
• 20x20400 sq ft
• 10x40400 sq ft
• 15x30450 sq ft
• 20x25500 sq ft
• 20x40800 sq ft
• 30x401,200 sq ft

Other Space Types

• Parking
• Enclosed Vehicle
• Locker
• Flex Space
• High Bay
• Office

Section 02

What Fits in a 10x35 Storage Unit

What Thirty-Five Feet Takes

• Travel trailers and fifth wheels to about 33 feet, subject to door opening height.
• Boats on trailers to about 32 to 33 feet overall, measured including the tongue.
• Motorhomes to about 33 feet, where height allows.
• Two vehicles nose to tail, with the rear one blocked in.
• Structural materials in 30 and 32 foot lengths.
• A vehicle plus shelving down both walls for gear, covers and spares.

Allow three to five feet of margin between the rig and the interior dimension. You need room to walk past it and to close the door behind it.

Shelving Down Both Walls

A 10x35 has 90 linear feet of wall. Shelving along both 35-foot walls and the back gives 80 linear feet of run, and at five shelves high that is about 400 linear feet of shelf. With a vehicle down the centre there is still room for a path on one side and shelving on the other.

Section 04

Who a 10x35 Storage Unit Is Right For

RV and Trailer Owners in the 30 to 33 Foot Range

The reason this size exists. A great many travel trailers and fifth wheels land just over what a 10x30 will take, and this solves it without stepping up to a 10x40.

Boat Owners With Larger Trailers

A hull advertised at 28 feet is routinely 32 on its trailer. Measure overall, then check it against this depth.

Contractors With Long Stock

Thirty and thirty-two foot lengths of steel, pipe and timber, with 400 linear feet of shelf for everything else.

Two-Vehicle Owners Storing Long Term

Two cars nose to tail, where you accept that the back one stays put until the front one moves.

Anyone Who Found a 10x40 Unavailable

There are more of these than there are 10x40s. If your rig fits, this is often the practical answer rather than waiting.

Section 06

How to Pack a 10x35 Storage Unit Efficiently

Thirty-five feet is a long way from the door, so what you can use of this unit is decided by the order you load it in rather than how tightly you pack.

1. Plan the Layout Before Anything Arrives

   At this size an unplanned load wastes more space than most people rent in total. Decide where vehicles, racking, heavy equipment and boxes go before the first item comes off the truck, and tell whoever is helping.

2. Racking Beats Stacking, Decisively

   Freestanding shelving or pallet racking along the walls turns floor area into usable volume and keeps everything individually reachable. Above about 300 square feet this is the single highest-return decision you will make.

3. Keep a Full-Length Aisle, and a Turning Space

   Run a clear path from the door to the back wall, and leave enough room near the door to turn with a hand truck or pallet jack. Losing roughly a third of the floor to access is the correct trade on a unit you will visit.

4. Heaviest and Least Needed at the Back

   Equipment, appliances and archive stock go furthest from the door. They are also the sturdiest platforms to stack against.

5. Build Upward to About 80 Inches

   Uniform cartons reach roughly 80 percent volume efficiency against 55 percent for mismatched sizes. On a unit this large that difference is measured in hundreds of cubic feet.

6. Prepare Vehicles and Fuel-Powered Equipment First

   Drain mowers, generators and power equipment, since fuel is not permitted inside. For a stored vehicle, clean it, inflate the tyres, and disconnect or tend the battery.

7. Shelving and Long Items First, Vehicle Last

   Everything that lives on the walls goes in before the rig does. Driving the vehicle in first means moving it every time you want something, which nobody keeps doing for long.

8. Photograph Each Zone and Keep the Map

   On a rental this size, running for a year or more, a few phone photos taken the day you load will save hours later. Label cartons on the face that points at the aisle.

Our full storage tips guide goes further on protecting furniture and preparing equipment for storage.

Section 08

What a 10x35 Storage Unit Costs and How to Think About Value

What a 10x35 costs depends on your market, the specific facility, whether the unit is climate-controlled and what is available when you book. Rather than publish a range that goes stale, we point you at live pricing for the locations near you.

The Cost Logic That Does Not Change

• Larger units cost less per square foot, but the curve flattens at the top of the range. The saving from stepping up is real between small units and much smaller between large ones.
• Availability is the real constraint at this size. There are far fewer of these than there are 10x10s, and they do not come free often. If one is available where you need it, that matters more than a small price difference.
• Compare against commercial rent, not against other units. For a business, the useful comparison is the price per square foot of warehouse or flex space in your market, plus its lease term, deposit and build-out. This is usually not close.
• Two units can beat one. Check a 10x35 against two 10x30 units at the locations near you. One is simpler; two are sometimes cheaper and let you separate what you need from what you do not.